HARD DISK DRIVE REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FD7VE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  4. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. A01FG68

      Remove the 2 screws.

    2. A01FHN5

      Detach the 2 claws and 2 clips.

    3. Pull out the multi-media module receiver assembly with bracket.

    4. Disconnect the connectors and remove the multi-media module receiver assembly with bracket.

  5. REMOVE NO. 2 RADIO BRACKET


    1. A01FHBTE02

      Remove the screw labeled A and ion generator bracket.

    2. Remove the 3 screws and No. 2 radio bracket.

  6. REMOVE HARD DISC


    1. A01FIYN

      Remove the 2 screws.

    2. A01FEA8

      Move the cover in the direction of the arrow shown in the illustration to remove it.

    3. A01FGA1

      Remove the hard disc in the direction of the arrow shown in the illustration.