BRAKE PEDAL REMOVAL

Tech Tips


  • Use the same procedure for the RHD and LHD vehicles.

  • The procedure listed below is for the LHD vehicles.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  4. REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. A01FECJ

      Disconnect the 2 connectors.

    2. Detach the 2 clamps from the brake pedal support.

    3. Remove the stop light switch Click here.

  5. REMOVE BRAKE PEDAL RETURN SPRING


    1. Remove the brake pedal return spring from the brake pedal support.

  6. REMOVE PUSH ROD PIN


    1. Remove the clip and push rod pin from the push rod clevis.

  7. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A01FFZG

      Remove the brake pedal support reinforcement set bolt.

    2. A01FG5Q

      Remove the 4 nuts from the brake pedal support assembly.

    3. Remove the brake booster assembly Click here.

    4. Remove the brake pedal support assembly.

  8. REMOVE BRAKE PEDAL PAD


    1. Remove the brake pedal pad from the brake pedal support assembly.