ION GENERATOR REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    A01FD7VE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the center instrument cluster finish panel.

    2. Detach the 9 clips and guide.

    3. Disconnect the connector and remove the center instrument cluster finish panel.

  4. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY


    1. A01FG68

      Remove the 2 bolts.

    2. A01FHN5

      Detach the 2 claws and 2 clips.

    3. Pull out the multi-media module receiver assembly.

    4. Disconnect the connectors and remove the multi-media module receiver assembly.

  5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    A01FHIHE01
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the No. 2 instrument panel register assembly.

    2. Using a moulding remover, detach the 7 clips.

    3. Disconnect the connectors and remove the No. 2 instrument panel register assembly.

  6. REMOVE NO. 1 ION GENERATOR SUB-ASSEMBLY

    A01FF8T

    1. Detach the claw.

    2. Remove the 2 screws and No. 1 ion generator sub-assembly.

    3. A01FDYVE01
      Text in Illustration
      *1 Rear Air Duct Sub-assembly

      Detach the 2 claws and remove the rear air duct sub-assembly.

  7. REMOVE AIR DUCT SUB-ASSEMBLY

    A01FFHJ

    1. Detach the 2 claws.

    2. Remove the clip and air duct sub-assembly.