HEATED OXYGEN SENSOR INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR


    1. A01FE15E01
      Text in Illustration
      *A for 2WD
      *B for AWD
      *1 Fulcrum Length

      for Bank 2 Sensor 2:

      Using SST, install the heated oxygen sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

    2. for AWD:

      Pass the heated oxygen sensor connector through the floor panel and install the grommet.

    3. for AWD:

      Connect the 2 clamps.

    4. for 2WD:

      Pass the heated oxygen sensor connector through the floor panel and install the grommet.

    5. A01FDYRE01
      Text in Illustration
      *1 Fulcrum Length

      for Bank 1 Sensor 2:

      Using SST, install the heated oxygen sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

  2. INSTALL FRONT FLOOR COVER LH (for AWD)


    1. Install the front floor cover LH with the 3 nuts and 3 grommets.

  3. CONNECT HEATED OXYGEN SENSOR CONNECTOR


    1. for Bank 1 Sensor 2:

      Connect the heated oxygen sensor connector.

    2. for Bank 2 Sensor 2:

      Connect the heated oxygen sensor connector.

  4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for 2WD)

    Click here

  6. INSTALL FRONT SEAT ASSEMBLY LH (for AWD)