ABSORBER CONTROL ACTUATOR (for Front Side) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER SHOCK ABSORBER CAP


    1. A01FDGN

      Remove the 3 nuts and upper shock absorber cap.

    2. Disconnect the connector.

  4. REMOVE ABSORBER CONTROL ACTUATOR


    1. Turn the absorber control actuator counterclockwise 40° to remove it from the front shock absorber with coil spring.

      A01FIFBE01
      Text in Illustration
      *A 2WD *B AWD
      *a 40° - -