ANTI-LOCK BRAKE SYSTEM, Diagnostic DTC:C1417

DTC Code DTC Name
C1417 High Power Supply Voltage Malfunction

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (housed in the actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation.

This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

The DTC is cancelled when the IG1 terminal voltage returns to normal.

DTC NO. DTC Detection Condition Trouble Area
C1417 The IG1 terminal voltage is 17.4 V or more for 0.8 seconds or more.

  • ECU-IG fuse

  • Battery

  • Charging system

  • Power source circuit

  • Internal power supply circuit of the brake actuator assembly (skid control ECU)

WIRING DIAGRAM

Refer to DTC C1241 Click here.

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. INSPECT BATTERY


    1. Check the battery voltage.

      Standard voltage
      11 to 14 V
      Result
      Result Proceed to
      OK A
      NG (for 1ND-TV) B
      NG (for 1NZ-FE) C
      NG (for 1NR-FE) D

    B

    CHECK OR REPLACE CHARGING SYSTEM OR BATTERY Click here

    C

    CHECK AND REPLACE CHARGING SYSTEM AND BATTERY Click here

    D

    CHECK AND REPLACE CHARGING SYSTEM AND BATTERY Click here

    A

  2. CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) (IG1)


    1. Disconnect the A55 or A57 brake actuator assembly (skid control ECU) connector.

    2. Turn the ignition switch to ON.

    3. A005JYBE01
      Text in Illustration
      *A except LHD with CVT
      *B for LHD with CVT
      *a

      Front view of wire harness connector

      (to Brake actuator assembly (Skid control ECU) )

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      except LHD with CVT
      Tester Connection Switch Condition Specified Condition
      A55-34 (IG1) - Body ground Ignition switch ON 11 to 14 V
      for LHD with CVT
      Tester Connection Switch Condition Specified Condition
      A57-34 (IG1) - Body ground Ignition switch ON 11 to 14 V

    4. Reconnect the A55 or A57 brake actuator assembly (skid control ECU) connector.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)

    OK

  3. RECONFIRM DTC


    1. Clear the DTCs Click here.

    2. Check if the same DTC is recorded Click here.

      Result
      Result Proceed to
      DTC (C1417) is not output A
      DTC (C1417) is output (for LHD) B
      DTC (C1417) is output (for RHD) C

    A

    CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) Click here

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) Click here

    C

    REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) Click here