Tech Tips
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | See page |
|---|---|---|
| Stop and Start System does not operate | Battery protection (System prohibit control) | |
| Engine hood courtesy switch circuit | ||
| Driver side door courtesy switch circuit (System prohibit control) | ||
| Driver side door courtesy switch circuit (CAN communication DTC U0140) | ||
| Driver side door courtesy switch circuit | ||
| Driver seat belt buckle switch circuit (System prohibits control) | ||
| Driver seat belt buckle switch circuit (CAN communication DTC U0140) | ||
| Seat inner belt assembly (Driver Side) | ||
| Air conditioning system (System prohibit control) | ||
| Air conditioning system (Terminal voltage TFAL) | ||
| Air conditioning system (for automatic A/C system) | ||
| Air conditioning system (for manual A/C system) | ||
| Brake booster vacuum is low (System prohibit control) | ||
| Brake booster vacuum is low | ||
| Cooler thermistor | ||
| Engine stop and start ECU (Backup boost converter) circuit | ||
| Park / Neutral position switch | ||
| Starter Signal Circuit | ||
| STA Signal Circuit | ||
| Starter Inrush Current Reduction Relay Circuit | ||
| Crank position sensor | ||
| ECM | ||
| No. 1 integration relay | ||
| Vacuum sensor | ||
| Brake booster assembly | ||
| Oil pump motor (Continuously variable transaxle assembly) | ||
| Starter assembly | ||
| The deceleration sensor 0 point calibration is performed | ||
| Airbag sensor assembly (Yaw rate sensor) | ||
| Skid control ECU (brake actuator assembly) | ||
| CAN communication system | ||
| Engine stop and start ECU | ||
| Battery*1 | ||
| Harness or connector | - | |
| The starter does not operate. | Battery | |
| Starter Assembly | ||
| Park/Neutral position switch | ||
| Entry and start system (w/ Entry and start system) | ||
| SFI system | ||
| Starter signal circuit | ||
| Cranking speed slows down. | Battery | |
| Starter inrush current reduction relay circuit | ||
| Starter Assembly | ||
| Stop and start cancel indicator does not operate | Combination meter assembly | |
| Indicator circuit (CAN communication DTC U0155) | ||
| Engine stop and start ECU | ||
| Stop and start indicator does not operate | Combination meter assembly | |
| Indicator circuit (CAN communication DTC U0155) | ||
| Engine stop and start ECU | ||
| Stop and Start system control cannot be canceled | Stop and start cancel switch | |
| ECAN terminal voltage | ||
| Stop and start cancel switch circuit | ||
| The engine does not stop due to Stop and Start system control (Stop and Start system operation is prohibited) | Engine hood courtesy switch circuit | |
| Driver side door courtesy switch circuit | ||
| Stop light switch circuit | ||
| Engine stop and start ECU | ||
| The control mode is not switched even after pressing the telltale light assembly (stop and start cancel switch assembly) | Stop and Start Priority Control System | |
| Control mode returns to default mode after turning ignition switch on (off to ON) | Stop and Start Priority Control System |
*1: If the vehicle has not been driven for a long time, the battery charge will be low and stop and start control operation will be prohibited. In this case, recharge the battery, initialize the integrated current value using GTS Click here.
Tech Tips
When the Data List item "Integrated Current" indicates 0 or more, initialization is not necessary.