|DTC Code||DTC Detection Condition||Trouble Area|
|C13AE/72||Incoherent information is detected in the non-volatile memory.||
Before performing work, turn the ignition switch off and wait approximately 20 seconds to make sure that the parking brake cannot operate.
When replacing the parking brake with bracket actuator assembly, perform zero point calibration Click here.
When DTC U0073/51, U0100/53, U0124/55 and/or U0129/52 is output together with DTC C13AE/72, inspect and repair trouble areas indicated by DTC U0073/51, U0100/53, U0124/55 and/or U0129/52 first Click here.
Clear the DTCs Click here.
Drive the vehicle at 30 km/h (19 mph) or more for 5 seconds or more.
Check for DTCs Click here.
|DTC is output.||A|
|DTC is not output.||B|
USE SIMULATION METHOD TO CHECK Click here
READ VALUE USING INTELLIGENT TESTER (COMMUNICATION MAIN BODY)
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Select the Data List mode on the intelligent tester Click here.
|Tester Display||Measurement Item/Range||Normal Condition||Diagnostic Note|
|Communication Main Body||
Communication with main body ECU/
ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
|ON is displayed when the ignition switch is ON||A|
|OFF is displayed when the ignition switch is ON||B|
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)