FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  3. REMOVE DECK FLOOR BOX RH


    1. Fold back the rear No. 2 floor board.

    2. Remove the deck floor box RH Click here.

  4. REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. A0040W5

      Disengage the 2 claws and remove the rear No. 3 floor board upper plate.

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT DOOR SCUFF PLATE


    1. A0042VN

      Disengage the 10 claws and remove the front door scuff plate LH.

  7. REMOVE REAR DOOR SCUFF PLATE


    1. A0040QT

      Disengage the 7 claws and remove the rear door scuff plate LH.

  8. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A0041VP

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A0040I7

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  12. REMOVE CENTER PILLAR LOWER GARNISH


    1. A0043XN

      Disengage the 2 claws and 2 clips, and remove the center pillar lower garnish LH.

  13. REMOVE CENTER PILLAR GARNISH


    1. A00400G

      Remove the screw.

    2. Using a clip remover, disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH and remove the center pillar garnish LH.

  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A0040B0

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A00400I

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A0040LU

      Remove the 2 bolts and front seat outer belt assembly.

  15. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A00446J

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.