AIRBAG CUT-OFF SWITCH REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 3 FLOOR BOARD


    1. Remove the rear No. 3 floor board.

  3. REMOVE DECK FLOOR BOX RH


    1. Fold back the rear No. 2 floor board.

    2. Remove the deck floor box RH Click here.

  4. REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATE


    1. A0040W5

      Disengage the 2 claws and remove the rear No. 3 floor board upper plate.

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


    1. A0041RH

      Pull the instrument panel finish panel end RH in the direction indicated by the arrow to disengage the 4 claws.

    2. A004387

      Disengage the guide as shown in the illustration.

    3. A0040M7

      Disengage the guide and remove the instrument panel finish panel end RH as shown in the illustration.

    4. w/ Airbag Cut Off Switch


      1. Disconnect the connector.

  7. REMOVE AIRBAG CUT-OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A0043PF

      Disengage the 2 claws to remove the airbag cut-off switch cylinder sub-assembly.