FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Note

Always use E10 "TORX" socket wrench when removing the front seat.

Tech Tips

The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)

    Click here

  3. REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)

    Click here

  4. REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT SEAT ASSEMBLY

    Click here

  7. REMOVE FRONT SEAT CUSHION COVER (for LHD)

    Click here

  8. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    1. A01UXNT

      Disengage the 5 clamps. (w/o Seat Heater System)

    2. A01V0AY

      Disengage the 5 clamps. (w/ Seat Heater System)

    3. Disconnect the seat heater connector. (w/ Seat Heater System)

    4. A01UZUN

      Disengage the 2 clamps.

    5. Remove the nut and the front seat inner belt assembly.