CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.
Note
Always use E10 "TORX" socket wrench when removing the front seat.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type A)
REMOVE CENTER FRONT FLOOR COVER (for Front Floor Cover Type B)
REMOVE FRONT FLOOR COVER RH (for Front Floor Cover Type B)
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE SEAT TRACK COVER OUTER LH (for Driver Side)
Move the seat to the foremost position.
Disengage the 2 claws to remove the seat track outer cover LH.
REMOVE SEAT TRACK COVER OUTER RH (for Front Passenger Side)
Tech Tips
Use the same procedure as for the LH side.
REMOVE FRONT SEAT ASSEMBLY LH
Disconnect the buckle switch connector.
Disconnect the front seat side airbag connector.
*1 | Slider | - | - |
Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat side airbag connector.
Using E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.
Move the seat to the rearmost position.
Using E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle. (w/ Vertical Adjuster)
Remove the front seat assembly LH.
Note
Be careful not to damage the vehicle body.
REMOVE FRONT SEAT ASSEMBLY RH
Tech Tips
Use the same procedure as for the LH side.