Tech Tips
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
INSTALL REAR TRAILING ARM ASSEMBLY
| *1 | Jack |
| *2 | Wooden Block |
Using a jack and wooden block, jack up the rear No. 2 suspension arm assembly to replicate standard vehicle height conditions.
CAUTION:
Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.
Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts (A) and 2 washers.
Install the rear trailing arm assembly to the body with the 2 bolts (B).
Slowly lower the rear No. 2 suspension arm assembly.
Install the No. 3 parking brake cable assembly to the rear trailing arm assembly with the 2 bolts.
Note
Do not twist the No. 3 parking brake cable assembly when installing it.
INSTALL REAR SPEED SENSOR
Install the rear speed sensor to the rear trailing arm assembly with the bolt.
Note
Do not twist the rear speed sensor when installing it.
CONNECT AIR TUBE (w/ Air Suspension)
Install 2 new O-rings, a new plate and a new No. 2 connector, and then connect the air tube to the rear pneumatic cylinder assembly.
Tech Tips
For the installing and connecting procedure of the tube (type 2), refer to Precaution of the suspension control system Click here.
INSTALL REAR WHEEL
INSPECT FOR AIR LEAK (w/ Air Suspension)
Inspect for air leaks Click here.
INSPECT AND ADJUST REAR WHEEL ALIGNMENT
Inspect and adjust the rear wheel alignment Click here.