OIL LEVEL SENSOR REMOVAL


  1. PRECAUTION (w/ Air Suspension)

    CAUTION:

    Be sure to read Precaution thoroughly before service Click here.

  2. REMOVE FRONT WHEEL RH

  3. REMOVE FRONT FENDER LINER RH

  4. REMOVE FRONT FENDER APRON SEAL RH

  5. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and gasket, and drain the oil into a container.

    3. Clean the oil pan drain plug.

    4. Install the oil pan drain plug with a new gasket.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  6. REMOVE ENGINE OIL LEVEL SENSOR


    1. A01NDV1

      Release the claw and disconnect the wire harness protector.

    2. A01NHWA

      Disconnect the oil pressure switch connector.

    3. A01NF0S

      Disconnect the engine oil level sensor connector.

    4. A01NG4W

      Remove the 4 bolts, then remove the oil level sensor and gasket.

    5. Remove the gasket from the oil level sensor.