TEMPERATURE SWITCH REMOVAL


  1. PRECAUTION (w/ Air Suspension)

    CAUTION:

    Be sure to read Precaution thoroughly before service Click here.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A01NGSF

      Remove the 4 clips and engine room side cover.

  3. REMOVE ENGINE ROOM SIDE COVER LH


    1. A01NFNX

      Remove the 4 clips and engine room side cover LH.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01NCUN

      Remove the 6 clips and cool air intake duct seal.

  5. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01NEB5

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the 2 retainers on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  6. REMOVE NO. 1 ENGINE UNDER COVER

  7. DRAIN COOLANT (for Engine)

    Note

    Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug and drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

    2. Remove the radiator cap from the radiator assembly.

    3. Loosen the 2 cylinder block drain cock plugs.

      A01ND3FE01
      Text in Illustration
      *1 Air Drain Cock Plug *2 Radiator Cap
      *3 Cylinder Block Drain Cock Plug *4 Radiator Drain Cock Plug

  8. REMOVE FRONT FLOOR COVER LH


    1. A01NH2WE01
      Text in Illustration
      *1 Bolt
      *2 Screw

      Remove the clip (A).

    2. Disconnect the 2 clips (B).

    3. Remove the 2 screws, 4 bolts and front floor cover LH.

  9. REMOVE TEMPERATURE SWITCH


    1. A01NDVK

      Disconnect the temperature switch connector.

    2. A01NHFA

      Using a union nut wrench (19 mm), remove the temperature switch.

      Note

      Do not apply any excessive force to the cooler pipe when removing the temperature switch.