REAR SPEED SENSOR (for AWD) REMOVAL

Tech Tips

If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.


  1. REMOVE PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. PRECAUTION (w/ Air Suspension)

    Note

    Be sure to read Precaution thoroughly before servicing Click here.

  3. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR WHEEL

  6. REMOVE REAR SPEED SENSOR LH


    1. A01NGAFE01
      Text in Illustration
      *1 No. 4 Bracket

      Disconnect the rear speed sensor connector.

    2. A01NGDYE01
      Text in Illustration
      *1 No. 4 Bracket

      Remove the nut and No. 4 bracket from the rear member assembly.

    3. A01NFLYE01
      Text in Illustration
      *1 No. 2 Bracket
      *2 No. 3 Bracket

      Remove the 2 bolts, No. 3 bracket and No. 2 bracket from the upper control arm assembly.

    4. A01ND3XE01
      Text in Illustration
      *1 No. 1 Bracket

      Remove the 2 bolts, No. 1 bracket and rear speed sensor from the rear trailing arm assembly and the rear axle carrier sub-assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

  7. REMOVE REAR SPEED SENSOR RH


    1. A01NHX4E01

      Disconnect the rear speed sensor connector.

    2. A01NGIWE01
      Text in Illustration
      *1 No. 4 Bracket

      Remove the nut and No. 4 bracket from the rear member assembly.

    3. A01NHXOE01
      Text in Illustration
      *1 No. 2 Bracket
      *2 No. 3 Bracket

      Remove the 2 bolts, No. 3 bracket and No. 2 bracket from the upper control arm.

    4. A01NDEQE01
      Text in Illustration
      *1 No. 1 Bracket

      Remove the 2 bolts, No. 1 bracket and rear speed sensor from the rear trailing arm assembly and the rear axle carrier sub-assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.