FRONT SPEED SENSOR REMOVAL

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. PRECAUTION (w/ Air Suspension)

    Note

    Be sure to read Precaution thoroughly before servicing Click here.

  3. REMOVE REAR DECK FLOOR BOX


    1. A01NDSY

      Remove the 3 clips and the rear deck floor box.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE FRONT WHEEL

  6. REMOVE FRONT SPEED SENSOR


    1. A01ND22

      Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01NI0T

      Remove the 5 clips and 3 screws, and turn back the front fender liner.

    3. A01NEEW

      Disconnect the front speed sensor connector and remove the 2 clamps.

    4. A01NHZCE03
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Remove the bolt and No. 2 sensor clamp from the body.

    5. A01NFA4E01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose

      Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.

    6. A01NHJJE02
      Text in Illustration
      *1 Resin Clamp

      Remove the bolt, resin clamp and front speed sensor.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.