СИСТЕМА SFI, Diagnostic DTC:P0500

DTC Code DTC Name
P0500 Vehicle Speed Sensor "A"

DESCRIPTION

Vehicles, which are equipped with ABS (Anti-lock Brake System), detect the vehicle speed using the skid control ECU and wheel speed sensor. The wheel speed sensor monitors the wheel rotation speed and sends a signal to the skid control ECU. The skid control ECU converts the wheel speed signal into a 4-pulse signal and transmits it to the ECM via the combination meter. The ECM determines the vehicle speed based on the frequency of the pulse signal.

A011AX0E13
DTC No. DTC Detection Condition Trouble Area
P0500

For Manual Transaxle:

While vehicle being driven, no vehicle speed sensor signal to ECM

(2 trip detection logic)

  • Open or short in speed signal circuit

  • Combination meter assembly

  • Brake actuator assembly

  • ECM

For CVT:

Following conditions (a) and (b) met for 2.0 seconds or more (1 trip detection logic)

(a) Transmission revolution sensor signal output 1000 rpm or more

(B) No vehicle speed sensor signal to ECM

WIRING DIAGRAM

A011AAPE01

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using an intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)


    1. Connect an intelligent tester to the DLC3.

    2. Turn the ignition switch to ON and turn the tester on.

    3. Enter the following menus: Powertrain / Engine and ECT/ Data List / Vehicle Speed.

    4. Drive the vehicle.

    5. Read the value displayed on the tester.

      Result
      Result Proceed to
      Values displayed on tester and speedometer display not equal A
      Values displayed on tester and speedometer display equal B

    B

    CHECK FOR INTERMITTENT PROBLEMS Click here

    A

  2. CHECK COMBINATION METER SYSTEM


    1. Inspect the circuits that send vehicle speed signals to this system in the meter system Click here.

    2. During inspection for the meter section, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.


    NEXT

  3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    1. Disconnect the combination meter assembly connector.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      D1-16 (+S) - A18-38 (SPD) Always Below 1 Ω

    4. Reconnect the combination meter assembly connector.

    5. Reconnect the ECM connector.


    NG

    CHECK HARNESS AND CONNECTOR (ECM - JUNCTION CONNECTOR) Click here

    OK

    REPLACE ECM Click here

  4. CHECK HARNESS AND CONNECTOR (ECM - JUNCTION CONNECTOR)


    1. Disconnect the ECM connector.

    2. Disconnect the junction connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      A18-38 (SPD) - D68-61 Always Below 1 Ω

    4. Reconnect the ECM connector.

    5. Reconnect the junction connector.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPAIR OR REPLACE JUNCTION CONNECTOR