WIPER SWITCH REMOVAL


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 2 STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column)

    A006X6S

    1. Detach the 4 claws and remove the lower No. 2 steering column cover.

  4. REMOVE UPPER STEERING COLUMN COVER

    Note

    Removing the steering column cover in an incorrect order will cause the steering column cover to break.


    1. A006UHI

      Push the right and left sides of the lower steering column cover and detach the 4 claws.

    2. A006U4E

      Insert fingers into the service hole of the lower steering column cover to detach the claw.

      Tech Tips

      Spread the claw to detach it.

    3. A006VX3

      Detach the 2 claws and remove the lower steering column cover.

    4. A006V1G

      Detach the claw and 2 pins, and remove the upper steering column cover.

  5. REMOVE LOWER STEERING COLUMN COVER

    Note

    Removing the steering column cover in an incorrect order will cause the steering column cover to break.


    1. A00OVRA

      Push the right and left sides of the lower steering column cover and detach the 4 claws.

    2. A00OUY7

      Insert fingers into the service hole of the lower steering column cover to detach the claw.

      Tech Tips

      Spread the claw to detach it.

    3. A00OQO0

      Turn the lower steering column cover to detach the 2 claws and remove the lower steering column cover as shown in the illustration.

  6. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A003BIE

      Disconnect the 2 connectors.

    2. Detach the claw and remove the windshield wiper switch assembly.

      Note

      If the claw is pushed with excessive force, it may break.