REAR WIPER MOTOR (for Wagon) INSTALLATION


  1. INSTALL REAR WIPER MOTOR GROMMET


    1. A003CXSE01
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire surface of the wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A003EHAE01
      Text in Illustration
      *1 Position Mark

      Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

  2. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. A003BO9

      Temporarily install the rear wiper motor assembly with the 3 bolts.

    2. Tighten the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the connector.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL ENGINE ROOM SIDE COVER


    1. A003B3G

      Attach the 4 clips install the engine room side cover.

  5. INSTALL REAR WIPER ARM


    1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

    2. A003EKKE01
      Text in Illustration
      *1 Wiper Arm Pivot Serrations
      *2 Wire Brush
      *3 Wiper Pivot Serrations

      Clean the serrations with a wire brush.

    3. A003DOGE01
      Text in Illustration
      *1 Defogger Line

      Set the head of the blade on the defogger line.

    4. Install the rear wiper arm with the nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Close the wiper arm head cap.

  6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. A003BFT

      Attach the 14 clips to install the back door trim board.

  7. INSTALL BACK DOOR SIDE GARNISH LH


    1. A003E8M

      Attach the 2 clips and claw to install the back door side garnish.

  8. INSTALL BACK DOOR SIDE GARNISH RH


    1. A003BK6

      Attach the 2 clips and claw to install the back door side garnish.

  9. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A003DA4

      Attach the 4 clips to install the upper back door trim panel