REAR WIPER MOTOR (for Wagon) REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A003DA4

      Detach the 4 clips and remove the back door trim panel.

  4. REMOVE BACK DOOR SIDE GARNISH LH


    1. A003E8M

      Detach the 2 clips and claw, and remove the back door side garnish.

  5. REMOVE BACK DOOR SIDE GARNISH RH


    1. A003BK6

      Detach the 2 clips and claw, and remove the back door side garnish.

  6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A003BFT

      Detach the 14 clips and remove the back door trim board.

  7. REMOVE REAR WIPER ARM


    1. A003EDX

      Open the wiper arm head cap.

    2. A003DT2

      Remove the nut and rear wiper arm.

  8. REMOVE REAR WIPER MOTOR ASSEMBLY


    1. A003BO9

      Disconnect the connector.

    2. Remove the 3 bolts and rear wiper motor assembly.

  9. REMOVE REAR WIPER MOTOR GROMMET


    1. A003B9K

      Remove the wiper motor grommet.