FRONT SEAT ASSEMBLY (for Power Seat) INSTALLATION

Note

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT SEAT ASSEMBLY


    1. A00DUNY

      Install the front seat assembly as shown in the illustration.

      Note


      • Be careful not to damage the vehicle body.

      • Make sure the seatback does not contact the shift lever knob.

      • Make sure the power seat switch knob does not contact the center pillar.

      Tech Tips

      Install the seat assembly through the door frame so that it passes under the steering wheel.

    2. Connect the seat wire connectors under the seat.

    3. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the power seat switch (slide switch) to move the seat to the foremost position.

    6. A00DPQUE02

      Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    7. Operate the power seat switch (slide switch) to move the seat to the rearmost position.

    8. A00DR77E01

      Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER


    1. A00DV0I

      Attach the 3 claws to install the cover.

  3. INSTALL FRONT SEAT INNER TRACK BRACKET COVER


    1. A00DUS7

      Attach the 3 claws to install the cover.

  4. INSTALL FRONT SEAT REAR OUTER TRACK COVER


    1. A00DTA3

      Attach the 2 claws to install the cover.

  5. INSTALL FRONT SEAT REAR INNER TRACK COVER


    1. A00DSCY

      Attach the 2 claws to install the cover.

  6. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  7. INSPECT FRONT SEAT ASSEMBLY


    1. Check the power seat operation Click here.

    2. Check the seat heater operation.


      1. Turn the ignition switch to ON.

      2. Operate the seat heater switch ON.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.