FRONT SEAT ASSEMBLY (for Power Seat) INSTALLATION

Note

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.

INSTALL FRONT SEAT ASSEMBLY
1. Install the front seat assembly as shown in the illustration.
  Note
  
  Be careful not to damage the vehicle body.
  
  Make sure the seatback does not contact the shift lever knob.
  
  Make sure the power seat switch knob does not contact the center pillar.
  Tech Tips
  
  Install the seat assembly through the door frame so that it passes under the steering wheel.
2. Connect the seat wire connectors under the seat.
3. Connect the cable to the negative (-) battery terminal.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
4. Temporarily install the front seat assembly with the 4 bolts.
5. Operate the power seat switch (slide switch) to move the seat to the foremost position.
6. Tighten the bolts in the order shown in the illustration.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
7. Operate the power seat switch (slide switch) to move the seat to the rearmost position.
8. Tighten the bolts in the order shown in the illustration.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
INSTALL FRONT SEAT OUTER TRACK BRACKET COVER
1. Attach the 3 claws to install the cover.
INSTALL FRONT SEAT INNER TRACK BRACKET COVER
1. Attach the 3 claws to install the cover.
INSTALL FRONT SEAT REAR OUTER TRACK COVER
1. Attach the 2 claws to install the cover.
INSTALL FRONT SEAT REAR INNER TRACK COVER
1. Attach the 2 claws to install the cover.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light Click here.
INSPECT FRONT SEAT ASSEMBLY
1. Check the power seat operation Click here.
2. Check the seat heater operation.
  1. Turn the ignition switch to ON.
  2. Operate the seat heater switch ON.
  3. Wait 5 minutes or more and confirm that the seat surface becomes warm.