AIRBAG CUT-OFF SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL RH


    1. A00EB64E01
      Text in Illustration
      *1 Protective Tape

      Place protective tape as shown in the illustration.

    2. Using a moulding remover B, detach the 3 clips and 4 claws.

    3. A00E9FJE01
      Text in Illustration
      *1 w/ Airbag Cut Off Switch Cylinder

      w/ Airbag Cut Off Switch Cylinder:


      1. Disconnect the connector.

    4. Detach the 2 hooks and remove the side panel.

  4. REMOVE AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A003BYU

      Detach the 2 claws and remove the cutoff switch cylinder.