STEERING PAD REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A003DD4

      Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A003E2XE01
      Text in Illustration
      *1 w/o Cruise Control System
      *2 w/ Cruise Control System

      Using a screwdriver, detach the 2 claws and remove the steering wheel cover.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE STEERING PAD


    1. A003E6G

      Using a screwdriver, detach the 2 springs and remove the steering pad.

    2. A003BC1

      Pull out the steering pad from the steering wheel as shown in the illustration and support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.