GENERATOR INSTALLATION


  1. INSTALL GENERATOR ASSEMBLY


    1. A003D7F

      Install the generator with the 3 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.

    2. Attach the wire clamp.

    3. A003E7D

      Connect the generator wire with the nut and bolt.

      Torque:
      for nut
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      for bolt
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    4. Connect the generator connector and attach the clamp.

    5. Install the terminal cap.

  2. INSTALL FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note


      • Make sure that the belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

      A00OTC1E01

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A00OVDVE01

      Install the front suspension member reinforcement with the 4 bolts.

      Torque:
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

  4. INSTALL REAR ENGINE UNDER COVER RH


    1. A00OQG7

      Install the under cover with the 5 clips.

  5. INSTALL ENGINE UNDER COVER


    1. A00EB0Y

      Install the engine under cover with the 11 clips.

  6. INSTALL FRONT LOWER BUMPER ABSORBER


    1. A00E73K

      Insert the 2 hooks of the front lower bumper absorber into the installation holes on the body to install the front lower bumper absorber .

    2. Install 8 bolts and 3 screws.

    3. A00E7US

      Install the 4 screws and 2 bolts.

  7. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A00E83X

      Install the radiator support opening cover with the 8 clips.

  8. INSTALL NO. 1 ENGINE COVER


    1. A003DQW

      Attach the 4 clips to install the No. 1 engine cover.

  9. INSTALL ENGINE ROOM SIDE COVER


    1. A003B3G

      Install the engine room side cover with the clip.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH


    1. Install the front drive shaft assembly RH Click here.