CLUTCH ACCUMULATOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE FRONT LOWER BUMPER ABSORBER


    1. A003EIP

      Remove the 4 screws and 2 bolts.

    2. A003ALH

      Remove the 8 bolts and 3 screws.

    3. Detach the 2 hooks of the front lower bumper absorber from the installation holes on the body and remove the front lower bumper absorber.

  5. REMOVE NO. 1 ENGINE UNDER COVER


    1. A006TQR

      Remove the 11 clips the engine under cover.

  6. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A003AXU

      Remove the 8 clips and radiator support opening cover.

  7. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A006X2R

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. REMOVE BATTERY CARRIER


    1. A006UUM

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  11. REMOVE CLUTCH ACCUMULATOR ASSEMBLY

    A003AZ9

    1. Using a union nut wrench, separate the clutch release cylinder to accumulator tube from the clutch accumulator assembly.

      Tech Tips

      Use a container to catch the fluid.

    2. Using a union nut wrench, disconnect the accumulator to flexible hose tube from the clutch accumulator assembly and flexible hose.

      Tech Tips

      Use a container to catch the fluid.

    3. Remove the bolt and accumulator to flexible hose tube from the clutch accumulator assembly.

    4. Remove the clip and separate the flexible hose from the clutch accumulator assembly.

    5. A003D9X

      Remove the 3 bolts and clutch accumulator assembly.