ECM REMOVAL


  1. PERFORM REGISTRATION


    1. Perform learning values save Click here.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER


    1. A003DQW

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A003AXU

      Remove the 8 clips and radiator support opening cover.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A00OSNR

      Disconnect the mass air flow meter connector.

    2. Disconnect the No. 2 ventilation hose.

    3. Disconnect the air cleaner hose.

    4. Detach the 4 clamps and remove the air cleaner cap.

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A00OUZE

      Remove the 3 bolts and air cleaner case.

  9. REMOVE NO. 1 AIR CLEANER INLET


    1. A003CM2

      Remove the clip and No. 1 air cleaner inlet.

  10. REMOVE NO. 2 AIR CLEANER INLET


    1. A003D57

      Remove the bolt and No. 2 air cleaner inlet

  11. REMOVE ECM


    1. Disconnect the 2 ECM connectors.


      1. A003B08

        Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    2. A003BIY

      Remove the 2 bolts and ECM with bracket.

    3. A003B5X

      Remove the 4 screws and 2 ECM brackets.