TCM REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A003B3G

      Remove the clip and engine room side cover.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A006V84

      Remove the 8 clips and radiator support opening cover.

  3. REMOVE REAR ENGINE UNDER COVER LH


    1. Remove the 5 clips and under cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  6. REMOVE BATTERY CARRIER


    1. A00E7A4

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  7. REMOVE TCM

    A006U3UE01

    1. Detach the claw, turn the lock lever and disconnect the connector from the TCM.

    2. A006SPR

      Remove the 2 bolts and pull up the TCM from the transaxle to remove it.