GLOW PLUG REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE NO. 1 ENGINE COVER


    1. A003DQW

      Hold the rear of the cover and slowly raise it to detach the clip on the rear of the cover. Continue to raise the cover to detach the 3 clips on the front and side of the cover and remove the cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  3. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY


    1. A00OSQME01
      Text in Illustration
      *1 Nut

      Remove the 3 bolts, 2 nuts and No. 2 EGR pipe.

    2. Remove the 2 gaskets.

  4. REMOVE ENGINE COVER BRACKET


    1. A00OSYP

      Remove the bolt, nut and engine cover bracket so that the glow plugs can be removed in a later step.

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. A00OURW

      Remove the 5 grommets.

    2. A00OTW8E01
      Text in Illustration
      *1 Wire Harness

      Remove the nut and disconnect the wire harness.

    3. Remove the 4 nuts and No. 1 glow plug connector.

  6. REMOVE GLOW PLUG ASSEMBLY


    1. A00OQFP

      Using a 10 mm deep socket wrench, remove the 4 glow plugs.