NAVIGATION SYSTEM Remote Touch Screen Does not Generate Vibration Feedback

DESCRIPTION

When each button displayed on the multi-display assembly is selected via touchpad operation, the remote touch (remote operation controller assembly) generates vibration feedback according to communication between the remote touch (remote operation controller assembly) and radio receiver assembly.

PROCEDURE


  1. CHECK MULTI-DISPLAY ASSEMBLY CUSTOMIZE SETTING


    1. Check that the touchpad vibration feedback force customize setting is not set to "LEVEL1 (No Vibration)" on the multi-display assembly screen.

      Click here

      OK
      The touchpad vibration feedback force customize setting is not set to "LEVEL1 (No Vibration)".
      Result
      Proceed to
      OK
      NG

    NG

    CHANGE CUSTOMIZE SETTING Click here

    OK

  2. REMOTE TOUCH SELF CHECK (CHECK VIBRATION FEEDBACK GENERATION CONDITION)


    1. Enter self-diagnostic mode.

      Click here

    2. Operate the touchpad laterally and check that the remote touch (remote operation controller assembly) generates vibration feedback.

      Note

      Since the touchpad may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the touchpad in self-diagnostic mode.

      OK
      Remote touch (remote operation controller assembly) generates vibration feedback.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

    REPLACE REMOTE TOUCH (REMOTE OPERATION CONTROLLER ASSEMBLY) Click here