VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1436

DTC Code DTC Name
C1436 Yaw Rate Sensor Malfunction

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) detects improper installation of the yaw rate and acceleration sensor or an abnormality in the difference between the yaw rate sensor value and the control value estimated based on the acceleration sensor, steering angle sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1436 Yaw Rate Sensor Malfunction

Either of the following is detected:


  1. With the vehicle stationary, the yaw rate sensor output value is not 0°/s.

  2. Abnormal comparison value.

  • Sensor installation

  • Yaw rate sensor (yaw rate and acceleration sensor)

CAUTION / NOTICE / HINT

Note

When replacing the yaw rate and acceleration sensor, perform zero point calibration and store system information.

Click here

PROCEDURE


  1. READ VALUE USING GTS (YAW RATE AND ACCELERATION SENSOR)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Select the Data List using the GTS.

      Click here


      Chassis > ABS/VSC/TRC > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Yaw Rate Sensor Yaw rate sensor Min.: -128°/s, Max.: 127°/s

      Vehicle stopped: 0°/s

      Turning right: -128 to 0°/s

      Turning left: 0 to 127°/s

      		 -
      Yaw Rate Sensor2 Yaw rate sensor 2 Min.: -128°/s, Max.: 127°/s

      Vehicle stopped: 0°/s

      Turning right: -128 to 0°/s

      Turning left: 0 to 127°/s

      		 -

      Chassis > ABS/VSC/TRC > Data List
      Tester Display
      Yaw Rate Sensor
      Yaw Rate Sensor2

    4. Check the yaw rate sensor output value displayed on the GTS.

      Result
      Result Proceed to
      NG (The yaw rate sensor output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning.) A
      NG (The yaw rate sensor output value is not 0°/s when the vehicle is stationary.) B
      OK C

      Note

      Check the yaw rate sensor signal after replacement.

      Click here

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here


    B

    REPLACE YAW RATE AND ACCELERATION SENSOR Click here

    C

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION


    1. Turn the engine switch off.

    2. Check that the yaw rate and acceleration sensor has been installed properly.

      Click here

      OK
      The sensor is tightened to the specified torque.
      The sensor is not installed in a tilted position.

      Note

      Check the yaw rate sensor signal after replacement.

      Click here

      Tech Tips

      If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

      Click here

      Result
      Proceed to
      OK
      NG

    OK

    REPLACE YAW RATE AND ACCELERATION SENSOR Click here

    NG

    INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY Click here