DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A40

DTC Code DTC Name
C1A40 ENG / EHV Device

DESCRIPTION

When the driving support ECU assembly receives a SFI system or automatic transmission system malfunction signal from the ECM, this DTC is stored.

When DTC C1A40 is stored, the SFI system or automatic transmission system DTC will also be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A40 ENG / EHV Device When the cruise control switch is on and the vehicle is being driven at a speed of 36 km/h (22 mph) or more, an SFI system malfunction signal is detected for 2 seconds or more.

  • SFI system

  • Automatic transmission system

  • ECM

  • Driving support ECU assembly

PROCEDURE


  1. CHECK FOR DTCs (SFI SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Check for DTCs.

      Click here


      Powertrain > Engine > Trouble Codes
      Result
      Result Proceed to
      SFI system DTCs are not output A
      SFI system DTCs are output B

    B

    GO TO SFI SYSTEM Click here

    A

  2. CHECK FOR DTCs (AUTOMATIC TRANSMISSION SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    5. Check for DTCs.

      Click here


      Powertrain > Engine > Trouble Codes
      Powertrain > ECT > Trouble Codes
      Result
      Result Proceed to
      Automatic transmission system DTCs are not output A
      Automatic transmission system DTCs are output B

    B

    GO TO AUTOMATIC TRANSMISSION SYSTEM Click here

    A

  3. REPLACE DRIVING SUPPORT ECU ASSEMBLY


    1. Replace the driving support ECU assembly.

      Click here

      Note

      When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

      Result
      Proceed to
      NEXT

    NEXT

  4. CHECK FOR DTCs (RADAR CRUISE)


    1. Clear the DTCs.

      Click here


      Powertrain > Radar Cruise > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check for DTCs.

      Click here


      Powertrain > Radar Cruise > Trouble Codes
      Result
      Result Proceed to
      DTC C1A40 is not output A
      DTC C1A40 is output B

    A

    END (DRIVING SUPPORT ECU ASSEMBLY WAS DEFECTIVE)

    B

    REPLACE ECM Click here