EXHAUST MANIFOLD INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. Install the No. 1 exhaust manifold heat insulator to the exhaust manifold sub-assembly LH (TWC: Front Catalyst) with the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Install the No. 1 exhaust manifold heat insulator to the exhaust manifold sub-assembly RH (TWC: Front Catalyst) with the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)


    1. Install a new gasket to the cylinder head sub-assembly.

    2. B007407E03

      Temporarily install the exhaust manifold sub-assembly LH (TWC: Front Catalyst) with 4 new nuts.

    3. Using a 12 mm deep socket wrench, tighten the 4 nuts in the order shown in the illustration.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH (TWC: Front Catalyst)


    1. Install a new gasket to the cylinder head sub-assembly.

    2. B0077V0E03

      Temporarily install the exhaust manifold sub-assembly RH (TWC: Front Catalyst) with 5 new nuts.

    3. Using a 12 mm deep socket wrench, tighten the 5 nuts in the order shown in the illustration.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  4. INSTALL NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE


    1. Install a new O-ring to the No. 2 engine oil level dipstick guide.

      Tech Tips

      Apply a light coat of engine oil to the O-ring.

    2. Install the No. 2 engine oil level dipstick guide to the cylinder block with the bolt.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    3. Install the engine oil level dipstick.

  5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY


    1. Install the No. 1 exhaust pipe support bracket sub-assembly with the 2 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  7. CONNECT HEATED OXYGEN SENSOR

    Click here

  8. INSTALL FRONT CENTER FLOOR BRACE

    Click here

  9. INSTALL FRONT CENTER FLOOR COVER LH (for Full Cover Type)

    Click here

  10. INSTALL FRONT CENTER FLOOR COVER RH (for Full Cover Type)

    Click here

  11. INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)

    Click here

  12. INSTALL FRONT SUSPENSION MEMBER BRACE

    Click here

  13. INSTALL AIR FUEL RATIO SENSOR

    Click here

  14. INSPECT FOR EXHAUST GAS LEAK

    Click here