THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE CENTER NO. 4 ENGINE UNDER COVER

    Click here

  3. DRAIN ENGINE COOLANT

    Click here

  4. REMOVE INTAKE AIR SOUND CREATOR (w/ Intake Air Sound Creator)

    Tech Tips

    Only perform this procedure when replacement of the intake air sound creator is necessary.


    1. B0073CC

      Loosen the hose clamp.

    2. Remove the bolt and intake air sound creator from the air cleaner hose assembly.

  5. REMOVE ENGINE ROOM SIDE COVER

    Click here

  6. DISCONNECT NO. 2 VENTILATION HOSE


    1. B007764

      Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B00776C

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disengage the wire harness clamp.

    3. B007431

      Disengage the No. 2 fuel vapor feed hose clamp from the air cleaner hose assembly.

    4. for RHD:


      1. B0072X5

        Disengage the union to check valve hose from the air cleaner hose assembly.

    5. B0073MR

      Disengage the 4 air cleaner cap clamps.

    6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  8. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B0075HJ

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake air surge tank assembly.

      Note

      If the throttle body with motor assembly has been struck or dropped, replace it.

    3. B0077RNC01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

  9. REMOVE THROTTLE BODY GASKET


    1. Remove the throttle body gasket from the intake air surge tank assembly.