STEERING WHEEL(w/ Lane Departure Alert System) INSTALLATION

CAUTION / NOTICE / HINT

Note

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the engine switch on (IG).
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE

INSTALL STEERING SHAKE DAMPER
1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
  
  Torque:
  
  2.4 N*m { 24 kgf*cm, 21 in.*lbf }
INSTALL NO. 1 SWITCH WIRE
1. Engage the 4 guides to install the No. 1 switch wire to the lower steering wheel boss cover.
  
  Note
  
  If the heater thermistor comes off the lower steering wheel cover, replace the steering wheel assembly.
INSTALL STEERING VIBRATION AND HEATER ECU

Click here
INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

Click here
INSTALL STEERING PAD SWITCH ASSEMBLY

Click here
INSTALL CRUISE CONTROL MAIN SWITCH

Click here
ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Click here
INSTALL STEERING WHEEL ASSEMBLY
1. *a Matchmark
  
  Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
2. Install the steering wheel assembly set nut.
  
  Torque:
  
  50 N*m { 510 kgf*cm, 37 ft.*lbf }
3. Connect the connector.
4. Connect the 2 connectors to the spiral cable with sensor sub-assembly.
5. Pass the wire harness over the 2 guides of the steering shake damper.
CHECK STEERING WHEEL CENTER POINT
INSTALL HORN BUTTON ASSEMBLY

Click here
PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (w/ VGRS)

Click here