OTTOMAN SWITCH REMOVAL


  1. REMOVE COWL SIDE TRIM BOARD RH (for LHD)


    1. A01CE66

      Remove the clip.

    2. Disengage the 2 clips, claw and 2 guides, and remove the cowl side trim board RH.

  2. REMOVE COWL SIDE TRIM BOARD LH (for RHD)


    1. A01CBNG

      Remove the clip(A).

    2. Disengage the clip, claw and 2 guides, and remove the cowl side trim board LH.

  3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  4. REMOVE NO. 3 FLOOR CARPET MOULDING


    1. A01CCWK

      Using a screwdriver, turn the clip 90° counterclockwise to release the 2 locks, and remove the 2 No. 3 floor carpet mouldings.

  5. REMOVE FRONT SEAT LEG COVER LH


    1. Operate the slide power seat switch knob and move the seat to the foremost position.

    2. A01CBK1

      Turn back the floor carpet.

    3. A01CF94

      Disengage the 6 claws and guide, and remove the front seat leg cover LH.

  6. REMOVE FRONT SEAT HEADREST ASSEMBLY

  7. REMOVE FRONT SEAT ASSEMBLY


    1. A01CCQQ

      Remove the 2 bolts on the rear side of the seat.

    2. Operate the slide power seat switch knob and move the seat to the rearmost position.

    3. A01CCMKE01

      Using a screwdriver wrapped with protective tape, disengage the 2 claws and guide, and open the cover.

    4. A01CCEZE01

      Using a screwdriver wrapped with protective tape, disengage the 2 claws and guide, and open the cover.

    5. A01CDSZ

      Remove the 2 bolts on the front side of the seat.

    6. Operate the slide power seat switch knob and move the seat to the center position. Also, operate the reclining power seat switch knob and move the seatback to the upright position.

    7. Operate the front seat power seat switch assembly to fully raise the ottoman.

    8. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    9. A01CCND

      Disconnect the 2 connectors.

    10. A01CCXM

      Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.

  8. REMOVE RECLINING POWER SEAT SWITCH KNOB


    1. A01CDAO

      Using a moulding remover, remove the reclining power seat switch knob.

  9. REMOVE SLIDE POWER SEAT SWITCH KNOB


    1. A01CFQK

      Using a moulding remover, remove the slide power seat switch knob as shown in the illustration.

  10. REMOVE FRONT SEAT CUSHION SHIELD


    1. A01CFNA

      Disengage the 2 hooks.

    2. A01CFUD

      Remove the 3 screws.

    3. Disengage the 8 claws and 2 guides.

    4. Disengage the 2 clamps from the front seat cushion shield.

    5. Disconnect the connector and remove the front seat cushion shield and No. 2 reclining adjuster inside cover LH.

  11. REMOVE OTTOMAN SWITCH


    1. A01CBSI

      Remove the 2 screws and the ottoman switch from the front seat cushion shield.