FRONT SEAT ASSEMBLY (for Manual Seat) REMOVAL


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • If the side airbag was deployed, replace the front seat assembly with a new one.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE COWL SIDE TRIM BOARD


    1. A01CFL6

      Remove the clip.

    2. Disengage the clip, claw and 2 guides, and remove the cowl side trim board RH.

  4. REMOVE FRONT DOOR SCUFF PLATE ASSEMBLY


    1. A01CFWN

      Disengage the claw, 6 clips and 3 guides, and remove the door scuff plate assembly RH.

  5. REMOVE NO. 3 FLOOR CARPET MOULDING


    1. A01CCSD

      Using a screwdriver, turn the clip 90° counterclockwise to release the lock, and remove the No. 3 floor carpet moulding.

  6. REMOVE FRONT SEAT LEG COVER


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. A01CE1V

      Turn back the floor carpet.

    3. A01CF35

      Disengage the 6 claws and the guide, and remove the front seat leg cover.

  7. REMOVE FRONT SEAT HEADREST ASSEMBLY

  8. REMOVE FRONT SEAT ASSEMBLY


    1. A01CBJR

      Remove the 2 bolts on the rear side of the seat.

    2. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    3. A01CCZSE01

      Using a screwdriver wrapped with protective tape, disengage the 2 claws and the guide, and open the cover.

    4. A01CBCYE01

      Using a screwdriver wrapped with protective tape, disengage the 2 claws and the guide, and open the cover.

    5. A01CEGB

      Remove the 2 bolts on the front side of the seat.

    6. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

    7. A01CAQF

      Disconnect each connector.

    8. A01CDOK

      Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.