FRONT FLOOR AIRBAG SENSOR REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT SEAT ASSEMBLY (for Passenger Side Power Seat)

    Tech Tips

    Refer to the instructions for Removal of the front seat assembly Click here.

  4. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

    Tech Tips


    • Refer to the instructions for Removal of the front seat assembly Click here.

    • Perform the same procedure as for the RH side.

  5. REMOVE CONSOLE BOX ASSEMBLY

    Tech Tips

    Refer to the instructions for Removal of the rear console box Click here.

  6. REMOVE FRONT FLOOR SIDE AIRBAG SENSOR COVER


    1. Turn back the floor carpet.

    2. A01CCEE

      Remove the double-sided tape and the front floor side airbag sensor cover.

      Note

      Do not reuse the double-sided tape.

  7. REMOVE FRONT FLOOR SIDE AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01CAIX

      Disconnect the connector from the front floor side airbag sensor.

      Note

      When disconnecting the airbag connector, take care not to damage the airbag wire harness.


      1. While holding the sides of the outer connector locking sleeve, slide the outer in the direction shown by the arrow.

        A01CBR3E01

      2. When the connector lock is released, the connectors can be disconnected.

        Tech Tips

        Be sure to hold both outer flank sides. Holding the top and bottom will make disconnection difficult.

    4. A01CC6FE01

      Remove the bolt and front floor side airbag sensor.

      Note

      Loosen the bolt while holding the front floor side airbag sensor because the front floor side airbag sensor pin (stopper) is easily damaged.