CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the RH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure up to "Remove Roof Headlining Assembly" Click here.

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 curtain shield airbag connectors.

      A01CFRX

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Disengage the 2 wire harness clamps.

    5. Remove the 12 bolts.

      A01CF7B

    6. Disengage the 12 hooks to remove the curtain shield airbag assembly.

      A01CCVQ