Click here

FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL INSTRUMENT PANEL WIRE ASSEMBLY


    1. A01CFSP

      Connect the 2 airbag connectors to install the instrument panel wire assembly to the front passenger airbag assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. Click here

    INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    1. A01CEKZ

      Engage the 5 hooks.

    2. Turn the front passenger airbag assembly in the direction indicated by the arrow shown in the illustration.

    3. A01CAVW

      Engage the 5 hooks and install the front passenger airbag assembly on the instrument panel.

    4. A01CBZE

      Install the 2 screws.

    5. A01CFCU

      Engage the wire harness clamp.

  3. Click here

    INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Tip:

    It is possible to install the instrument panel register assembly with the upper instrument panel sub-assembly still installed to the vehicle body. Refer to the reassembly procedure for the upper instrument panel sub-assembly.


    1. A01CEGJ

      Engage the 5 claws.

      Note:

      • Do not allow the wire harness to get caught in the claws.

      • Make sure that the claws are fully engaged.

    2. Engage the 9 claws.

    3. Install the 2 clips.

    4. A01CBP0

      Connect the connector.

    5. Install the 2 passenger airbag bolts <A>.

      20 N*m 204 kgf*cm 15 ft.*lbf
    6. A01CC6KE01

      Install the upper instrument panel sub-assembly with the 3 screws <B>.

  4. Click here

    CONNECT INSTRUMENT PANEL WIRE ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01CFH6

      Connect the connector.

      Note:

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    4. Engage the wire harness clamp.

  5. Click here

    INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Tip:

    Refer to the procedure from "Install No. 3 Instrument Cluster Finish Panel Garnish" (Click here).

  6. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  7. Click here

    PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check (Click here).

  8. Click here

    INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light (Click here).