SIDE AIRBAG SENSOR (for Rear Side) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the RH side.


  1. INSTALL DOOR SIDE AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01CBWYE01

      Insert the pin (stopper) into the body hole and install the door side airbag sensor to the slide door with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.

    4. A01CDPU

      Connect the connector to the door side airbag sensor.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.


      1. Connect the connector as shown in the illustration (When locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

        A01CE5UE01

        Tech Tips

        When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.

    5. Check that there is no looseness in the installation parts of the door side airbag sensor.

  2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. Connect the connector.

    2. A01CG64

      Engage the 15 clips and 5 claws to install the rear door trim board to the slide door panel.

    3. Using a T25 "TORX" socket wrench, install the screw.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.

  5. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.