GENERATOR INSTALLATION


  1. INSTALL GENERATOR ASSEMBLY


    1. A01CES5

      Confirm that the wire harness of the crankshaft position sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.

    2. A01CEOYE01

      Install the generator assembly with the 2 bolts.

      Torque:
      Bolt A
      52 N*m  { 530 kgf*cm, 38 ft.*lbf }
      Bolt B
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    3. Install the generator wire to terminal B with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 88 in.*lbf }

    4. Install the clamp bracket with the bolt.

      Torque:
      7.7 N*m  { 79 kgf*cm, 68 in.*lbf }

    5. Attach the clamp and connect the generator connector to the generator.

  2. INSTALL V-RIBBED BELT

    Tech Tips

    Click here.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


    1. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL RADIATOR RESERVE TANK BRACKET


    1. Install the radiator reserve tank bracket with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  5. INSTALL RADIATOR RESERVE TANK ASSEMBLY


    1. Install the radiator reserve tank assembly to the radiator reserve tank bracket.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the No. 1 and No. 2 water by-pass hoses.

    3. Connect the wire harness clamp to the radiator reserve tank assembly.

  6. INSTALL REAR ENGINE UNDER COVER RH

  7. INSTALL FRONT WHEEL RH

  8. INSTALL RADIATOR COVER SUB-ASSEMBLY


    1. Install the radiator cover sub-assembly with the 4 clips.