Click here

NAVIGATION RECEIVER REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    (Click here)

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A01CD4S

      Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.

  4. Click here

    REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01CG21E02

      Apply protective tape to the area shown in the illustration.

    2. A01CEQF

      Move the shift lever to N.

    3. Disengage the 3 claws as shown in the illustration.

      Note:

      Make sure to disengage the lower claws first. The center instrument cluster finish panel sub-assembly may be damaged if the upper claws are disengaged first.

    4. A01CCCC

      Disengage the 20 claws.

      Note:

      Make sure to disengage the lower claws first. The center instrument cluster finish panel sub-assembly may be damaged if the upper claws are disengaged first.

    5. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.

  5. Click here

    REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    1. A01CEYM

      Disengage the 4 claws and remove the air conditioning control assembly.

    2. Disconnect the connector.

  6. Click here

    REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


    1. A01CF60E01

      Apply protective tape at the position shown in the illustration.

      Table 1. Text in Illustration
      *1 Protective Tape
    2. A01CASV

      Remove the 4 bolts.

    3. A01CAT5

      Disengage the 4 claws and pull the navigation receiver assembly with bracket toward the rear of the vehicle.

    4. w/ Front Center Speaker:


      1. A01CAYC

        Disengage the claw and disconnect the connector as shown in the illustration.

    5. Disconnect each connector and remove the navigation receiver assembly with bracket.

  7. Click here

    REMOVE NO. 2 RADIO RECEIVER BRACKET


    1. A01CG7G

      Remove the 4 screws and No. 2 radio receiver bracket.

  8. Click here

    REMOVE NO. 1 RADIO RECEIVER BRACKET


    1. A01CCR4

      Remove the 4 screws and No. 1 radio receiver bracket.

  9. Click here

    REMOVE NAVIGATION RECEIVER ASSEMBLY

  10. Click here

    REMOVE HARD DISK DRIVE


    1. A01CB6R

      Remove the 2 screws.

    2. Disengage the 2 guides and remove the cover.

    3. A01CELSE01

      Using a screwdriver with its tip taped with protective tape, slide the hard disk drive in the direction shown by the arrow to remove it.

      Table 2. Text in Illustration
      *1 Protective Tape
  11. Click here

    REMOVE NAVIGATION ECU SUB-ASSEMBLY