REAR COIL SPRING INSTALLATION

INSTALL REAR LOWER COIL SPRING INSULATOR

1. 

   Align the 2 protrusions to the guide holes and install the rear lower coil spring insulator.

   Note:

   Make sure to insert the 2 protrusions fully into the guide holes.

INSTALL REAR COIL SPRING

1. 

   Align the matchmarks on the rear coil spring with the SST hooks and install SST to the rear coil spring as shown in the illustration.

   09727-30021

   Tip:

   When installing a new coil spring, adjust the SST installation position by using the matchmarks on the original spring as a reference.

2. Using SST, compress the rear coil spring.

   09727-30021

   Note:

   Do not use an impact wrench. It will damage SST.

3. 

   Align the stopper part of the rear upper coil spring insulator with the rear coil spring tip, and install the rear upper coil spring insulator to the rear coil spring.

4. 

   Confirm that the rear upper coil spring insulator and the rear lower coil spring insulator are installed securely before installing the rear coil spring.

   Clearance (A)
   10 mm (0.393 in.) or less

   Tip:

   If it is difficult to align the rear upper coil spring insulator, a minimal amount of lithium soap base glycol grease may be applied to the insulator.

5. 

   Align the stopper part of the rear lower coil spring insulator with the rear coil spring tip, and temporarily install the rear coil spring with SST to the vehicle.

6. Release SST and install the rear coil spring to the vehicle.

   09727-30021

   Note:
   

   • Do not use an impact wrench. It will damage SST.

   • Make sure that the rear upper coil spring insulator and rear lower coil spring insulator are correctly aligned and do not fall out of position when installing the spring.

7. Remove SST from the rear coil spring.

   09727-30021

INSTALL TAIL EXHAUST PIPE ASSEMBLY (for RH Side)

for 2AZ-FE: (Click here)

for 2GR-FE: (Click here)

INSPECT FOR EXHAUST GAS LEAK (for RH Side)

INSTALL REAR WHEEL

STABILIZE SUSPENSION

1. Lower the vehicle and bounce it up and down several times to stabilize the rear suspension.

INSPECT REAR WHEEL ALIGNMENT

1. Inspect the rear wheel alignment (Click here).

PLACE FRONT WHEELS FACING STRAIGHT AHEAD

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL