CRUISE CONTROL MAIN SWITCH INSTALLATION


  1. INSTALL CRUISE CONTROL MAIN SWITCH


    1. A01CE84

      Insert the cruise control main switch to the steering wheel assembly as shown in the illustration.

    2. Engage the pin and install the cruise control main switch.

    3. A01CDCH

      Install the 2 screws.

    4. A01CGIY

      Connect the connector.

    5. Engage the clamp.

  2. INSTALL STEERING PAD


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01CAO9

      Connect the airbag connector to the steering pad.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

    4. Connect the horn connector to the steering pad.

    5. A01CDQ6E01

      Confirm that the circumference groove of each "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

    6. Using a "TORX" socket wrench (T30), tighten the 2 "TORX" screws.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

  3. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A01CBQQ

      Engage the claw to install the lower No. 3 steering wheel cover.

  4. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A01CEA7

      Engage the claw to install the lower No. 2 steering wheel cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSPECT STEERING PAD


    1. A01CEFY

      Visually check for defects with the steering pad installed on the vehicle.


      1. The defects are as follows:


        • Cuts on the surface and in the grooves of the steering pad

        • Small cracks on the surface and in the grooves of the steering pad

        • Significant discoloration on the surface and in the grooves of the steering pad

        OK
        No defects are found.

        Tech Tips

        If any of the defects is found, replace the steering pad with a new one.

    2. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system Click here.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here