ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A015A8OE02

      Зафиксируйте коленчатый вал с помощью SST.

      SST
      09213-70011
      09330-00021
    2. A0155RD

      Выверните 10 болтов и снимите заднюю распорную втулку ведущего диска, ведущий диск и зубчатый диск датчика положения коленчатого вала.

  5. REMOVE REAR CRANKSHAFT OIL SEAL


    1. Using a knife, cut off the lip of the oil seal.

    2. A0155KLE01
      Text in Illustration
      *1 Cut Position

      Using a screwdriver, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Do not damage the surface of the oil seal press fit hole and crankshaft.