ECM СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DISCONNECT CONNECTOR HOLDER BLOCK


    1. A015DXD

      Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.

  4. REMOVE ECM


    1. A0155SHE02
      Text in Illustration
      *a Lock
      *b Push

      Raise the 2 levers while pushing the locks on the 2 levers.

      Note

      Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

    2. Disconnect the 2 connectors.

    3. A0156EH

      Remove the 4 bolts and ECM.

  5. REMOVE GASKET


    1. A01594V

      Peel off the gasket.

    2. A015CHOE02
      Text in Illustration
      *1 Cloth

      Spray gasket remover or equivalent on the remaining tape of the gasket.

      Note

      When using gasket remover or equivalent, cover the ECM connectors with a cloth.

    3. A01569O

      Remove the tape of the gasket without using bladed objects.