FRONT BUMPER (w/ Winch) INSTALLATION

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.


  1. INSTALL FRONT UPPER CENTER BUMPER RETAINER


    1. Install the front upper center bumper retainer with the 3 bolts.

  2. INSTALL HEADLIGHT ASSEMBLY LH


    1. for Halogen Headlight:

      Click here

    2. for HID Headlight:

      Click here

  3. INSTALL HEADLIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. INSTALL FRONT BUMPER SIDE SUPPORT LH


    1. Attach the 3 clips to install the front bumper side support LH.

    2. Install the 2 screws.

  5. INSTALL FRONT BUMPER SIDE SUPPORT RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. INSTALL FRONT BUMPER EXTENSION LH


    1. Install the front bumper extension LH with the 3 bolts.

  7. INSTALL FRONT BUMPER EXTENSION RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL FRONT BUMPER COVER


    1. w/ Fog Light:

      Connect the No. 4 engine room wire connector.

    2. Connect the winch control wire connector and attach the 10 claws to install the front bumper cover.

    3. Install the 3 clips, 4 screws and 4 bolts.

    4. Using a T30 "TORX" socket, install the 6 screws.

  9. INSTALL RADIATOR GRILLE ASSEMBLY


    1. A0157G3E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the radiator grille assembly.

    2. Remove the 3 screws.

    3. Detach the 2 clips and 8 claws, and remove the radiator grille assembly.

    4. w/ Wide View Front Monitor System:


      1. Disconnect the connector.

  10. INSTALL FRONT BUMPER WINCH COVER SUB-ASSEMBLY


    1. Attach the 3 guides.

    2. Attach the 2 claws and front bumper winch cover sub-assembly.

  11. INSTALL UPPER RADIATOR SUPPORT SEAL


    1. Install the radiator support seal with the 7 clips.

      A015BVKE02

  12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


    1. Push in the clip to install the front fender splash shield sub-assembly LH.

    2. Install the 3 bolts and screw.

  13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Push in the clip to install the front fender splash shield sub-assembly RH.

    2. Install the 3 bolts and 2 screws.

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. ADJUST HEADLIGHT AIMING


    1. for Halogen Headlight:


      1. Click here

    2. for HID Headlight:


      1. Click here

  16. ADJUST FOG LIGHT AIMING (w/ Fog Light)

    Click here