REAR DOOR BELT MOULDING REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH


    1. A015B1YE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 4 claws and remove the rear door inside handle bezel LH.

      Tech Tips

      Tape the screwdriver tip before use.

  4. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH


    1. A015ALM

      Using a moulding remover, detach the 7 claws.

    2. Disconnect the connector and remove the armrest base panel.

  5. REMOVE ASSIST GRIP COVER LH


    1. A015D94

      Using a moulding remover, detach the 9 claws and remove the assist grip cover LH.

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A0155STE01

      Remove the 3 screws.

    2. Remove the 9 clips.

    3. Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

      Tech Tips

      Make sure that the pin labeled A in the illustration is detached from the door panel.

    4. Disconnect the connector and remove the rear door trim board sub-assembly LH.

    5. A0159D6

      Disconnect the 2 cables from the rear door inside handle sub-assembly LH.

  7. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH


    1. A015864

      Detach the 4 clips and remove the rear inner door glass weatherstrip LH from the rear door trim board sub-assembly LH.

      Note


      • Squeeze the metal clip to remove it.

      • The metal clip may be deformed if it is forcibly pulled.

  8. REMOVE REAR DOOR SERVICE HOLE COVER LH


    1. A0158QNE01

      Using a clip remover, detach the 6 clamps.

    2. Remove the bolt and disconnect the 2 connectors.

    3. Remove the rear door service hole cover LH.

      Tech Tips

      Remove the remaining tape on the door.

  9. REMOVE REAR DOOR GLASS RUN LH


    1. A015C0T

      Remove the rear door glass run LH from the window frame.

  10. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH


    1. A0159WG

      Remove the 2 bolts.

    2. Remove the screw and rear door rear lower window frame sub-assembly LH.

  11. REMOVE REAR DOOR QUARTER WINDOW GLASS LH


    1. A0157CH

      Remove the rear door quarter window glass LH and rear door quarter window weatherstrip LH as a unit as shown in the illustration.

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH


    1. A0158QI

      Remove the rear door glass sub-assembly LH from the rear door window regulator sub-assembly LH as shown in the illustration.

      Note

      Do not damage the door glass.

  13. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

    A0158QUE01

    1. Put protective tape around the belt moulding.

    2. A0158XC

      Detach the claw and remove the belt moulding.